xB L4-2.4L (2AZ-FE) (2009)
![background image](/scion/xb/l4-2.4l_(2az-fe)/Page-1140008.png)
NOTICE: Keep the groove where you are fitting the boot free of grease.
8. INSTALL FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP LH
CAUTION: Wear protective gloves while performing the operation and be careful to avoid cutting your hands or other body parts.
(a) Install a new boot clamp onto the outboard joint boot and temporarily bend the lever.
NOTICE:
-
When temporarily bending the lever, make sure not to deform the band and lever.
-
Set the clamp correctly in the guide groove and align it with the interior of the vehicle as much as possible.
(b) With the joint on the working surface, use your body weight to press down on the joint with one hand. Then, roll the joint forward, as shown in
the illustration, and press the lever in until a "click" sound is heard.
NOTICE:
-
Do not damage the deflector.
-
Make sure the joint is in full contact with the joint surface at all times.