xD L4-1.8L (2ZR-FE) (2008)
(e) Remove the No. 2 luggage compartment door name plate.
Installation
EXTERIOR: NAME PLATE: INSTALLATION
INSTALLATION
1. INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
(a) Clean the attachment surface.
(1) Using an infrared light, heat the double-sided adhesive tape remaining on the back door panel.
HINT: Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.
(2) Using a piece of cloth, rub the double-sided adhesive tape off the back door panel while it is hot from the infrared light.
NOTE: Installing the No. 2 luggage compartment door name plate while any double-sided tape remains on the luggage compartment door
panel may cause adhesion failure. Therefore, completely remove the double-sided tape.
(3) Using a non-residue solvent, clean the attachment surface.
(b) Install a new No. 2 luggage compartment door name plate as shown in the illustration.
Installation position:
NOTE: Install the No. 2 luggage compartment door name plate in an environment where the ambient temperature is over 20°C (68°F). If it is
below 20°C (68°F), using an infrared light, heat the back door panel and the No. 2 luggage compartment door name plate up to 20 to 30°C (68
to 86°F) and install the No. 2 luggage compartment door name plate.
2. INSTALL SYMBOL EMBLEM