xD L4-1.8L (2ZR-FE) (2008)
(b) Remove the visor shaft from the visor holder.
(c) Disengage the 2 springs and remove the visor.
39. REMOVE VISOR ASSEMBLY LH
HINT: Use the same procedure as for the RH side.
40. REMOVE VISOR HOLDER RH
(a) Turn the visor holder approximately 45° and pull it out as shown in the illustration.
(b) Disengage the 2 claws and remove the visor holder.
41. REMOVE VISOR HOLDER LH
HINT: Use the same procedure as for the RH side.
42. REMOVE ROOM LIGHT ASSEMBLY
(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light lens.
(b) Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the 2 room light covers.