xD L4-1.8L (2ZR-FE) (2008)
(c) Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light.
(d) Remove the roof wire from the claw on the room light.
(e) Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light switch base.
43. REMOVE MAP LIGHT ASSEMBLY
(a) Using a moulding remover D, disengage the 4 claws and remove the map light.
(b) Disconnect the map light connector.
44. REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY See: Dashboard / Instrument Panel/Service and
Repair/Upper Instrument Panel/Removal
45. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY See: Instrument Panel, Gauges and Warning Indicators/Instrument
Cluster / Carrier/Service and Repair/Combination Meter/Removal