xD L4-1.8L (2ZR-FE) (2008)
(a) Install a new stop light switch mounting adjuster onto the pedal support.
7. INSTALL STOP LIGHT SWITCH ASSEMBLY
(a) Insert the stop light switch into the adjuster until it just touches the brake pedal.
NOTE: Do not depress the brake pedal.
(b) Make a quarter turn clockwise to install the stop light switch.
NOTE: Do not depress the brake pedal.
HINT: The turning torque for installing the stop light switch:
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)
(c) Check the stop light switch clearance.
Stop light switch clearance:
0.5 to 2.6 mm (0.020 to 0.102 in.)
(d) Engage the harness clamp to the pedal support.
(e) Connect the connector to the stop light switch.
8. INSTALL COMBINATION METER ASSEMBLY See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service
and Repair/Combination Meter/Installation
9. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY See: Instrument Panel, Gauges and Warning Indicators/Instrument
Cluster / Carrier/Service and Repair/Combination Meter/Installation
10. INSPECT AND ADJUST BRAKE PEDAL See: Adjustments