xD L4-1.8L (2ZR-FE) (2008)
Parking Brake Lever: Service and Repair
Installation
PARKING BRAKE: PARKING BRAKE LEVER: INSTALLATION
INSTALLATION
1. INSTALL PARKING BRAKE SWITCH ASSEMBLY
(a) Install the parking brake switch with the screw.
Torque: 0.9 Nm (9 kgf-cm, 8 in-lbf)
2. INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY
(a) Install the parking brake lever with the 3 bolts.
Torque: 13 Nm (127 kgf-cm, 9 ft-lbf)
(b) Connect the parking brake switch connector.
3. INSTALL NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY
(a) Install the parking brake pull rod to the parking brake lever.
(b) Provisionally install the wire adjusting nut and lock nut.
4. INSPECT PARKING BRAKE LEVER TRAVEL See: Adjustments
5. ADJUST PARKING BRAKE LEVER TRAVEL See: Adjustments
6. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Installation
7. INSTALL CONSOLE BOX CARPET See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Installation
8. INSTALL REAR CONSOLE BOX COVER See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Installation
9. INSTALL UPPER CONSOLE PANEL See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Installation