xD L4-1.8L (2ZR-FE) (2008)
(e) Tighten the flange bolt with the camshaft timing gear fixed in place.
Torque: 54 Nm (551 kgf-cm, 40 ft-lbf)
(f) Check that the camshaft timing gear can move to the retard angle side (the right direction) and is locked in the most retarded position.
8. INSTALL CAMSHAFT TIMING EXHAUST GEAR ASSEMBLY
(a) Check that the knock pin is installed on the camshaft.
(b) Put the camshaft timing exhaust gear and camshaft together by aligning the key groove and straight pin.
(c) Lightly press the gear against the camshaft, and turn the gear. Push further at the position where the pin enters the groove.
NOTE: Be sure not to turn the camshaft timing exhaust gear in the retard direction (the right angle).
(d) Check that there is no clearance between the gear's flange and the camshaft.
(e) Tighten the flange bolt with the camshaft timing exhaust gear fixed.
Torque: 54 Nm (551 kgf-cm, 40 ft-lbf)
(f) Check the camshaft timing exhaust gear lock.
(1) Make sure that the camshaft timing exhaust gear is locked.
9. INSTALL CRANKSHAFT TIMING GEAR OR SPROCKET See: Service and Repair/Overhaul/Reassembly
10. INSTALL NO. 1 CHAIN VIBRATION DAMPER See: Service and Repair/Overhaul/Reassembly
11. INSTALL CHAIN SUB-ASSEMBLY See: Service and Repair/Overhaul/Reassembly
12. INSTALL CHAIN TENSIONER SLIPPER See: Service and Repair/Overhaul/Reassembly
13. INSTALL NO. 2 CHAIN VIBRATION DAMPER See: Service and Repair/Overhaul/Reassembly