xD L4-1.8L (2ZR-FE) (2008)
14. INSTALL TIMING CHAIN OR BELT COVER OIL SEAL
(a) Using SST, tap in a new oil seal until its surface is flush with the timing gear case edge.
SST: 09223-22010
(b) Apply a light coat of MP grease to the lip of the oil seal.
NOTICE:
-
Keep the lip free of foreign matter.
-
Do not tap on the oil seal at an angle.
-
Make sure that the oil seal edge does not stick out of the timing chain cover.
15. INSTALL TIMING CHAIN OR BELT COVER SUB-ASSEMBLY See: Service and Repair/Overhaul/Reassembly
16. INSTALL CRANKSHAFT PULLEY See: Service and Repair/Overhaul/Reassembly
17. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY See: Service and Repair/Overhaul/Reassembly
18. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY See: Service and Repair/Overhaul/Reassembly
19. INSTALL AIR TUBE ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Unit/Installation
20. INSTALL NO. 2 VENTILATION HOSE See: Service and Repair/Removal and Replacement/Engine Unit/Installation
21. INSTALL RADIO SETTING CONDENSER See: Service and Repair/Removal and Replacement/Engine Unit/Installation
22. INSTALL IGNITION COIL ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Unit/Installation
23. INSTALL THERMOSTAT See: Cooling System/Thermostat/Service and Repair/Installation
24. INSTALL WATER INLET See: Cooling System/Thermostat/Service and Repair/Installation
25. INSTALL NO. 3 WATER BY-PASS HOSE
(a) Install the No. 3 water by-pass hose with the clip.
26. INSTALL WATER INLET HOSE