xD L4-1.8L (2ZR-FE) (2008)
Minimum length:
38.5 mm (1.516 in.)
If the length is not as specified, replace the compression spring.
(b) Install the 2 exhaust pipe supports.
(c) Install the tail exhaust pipe assembly and a new exhaust pipe gasket with the 2 compression springs and 2 bolts.
Torque: 43 Nm (438 kgf-cm, 32 ft-lbf)
(d) Check the exhaust pipe supports.
NOTE: Install the exhaust pipe support onto the pipe retaining support.
5. INSTALL HEATED OXYGEN SENSOR See: Powertrain Management/Computers and Control Systems/Oxygen Sensor/Service and
Repair/Heated Oxygen Sensor/Installation
6. INSPECT FOR EXHAUST GAS LEAK
7. INSTALL CONSOLE BOX FRONT
8. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
9. INSTALL CONSOLE BOX CARPET
10. INSTALL REAR CONSOLE BOX COVER
11. INSTALL UPPER CONSOLE PANEL
12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)