xD L4-1.8L (2ZR-FE) (2008)
REASSEMBLY
1. INSTALL FRONT EVAPORATOR TEMPERATURE SENSOR See: Evaporator Temperature Sensor / Switch/Service and Repair/Installation
2. INSTALL DRAIN COOLER HOSE
(a) Install the drain cooler hose.
3. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
HINT: If a new cooler evaporator is installed, add compressor oil to the cooler evaporator as follows.
Compressor oil:
ND-OIL8 or equivalent. Add 40 cc (1.35 fl. oz.)
(a) Install the cooler evaporator.
(b) Engage the 4 claws and install the heater case lower.
(c) Install the 3 screws.
(d) Engage the evaporator temperature sensor connector clamp.