xD L4-1.8L (2ZR-FE) (2008)
(d) COMBINATION METER ECU
HINT: DTC communication uses the CAN communication system.
(e) AIR CONDITIONING AMPLIFIER
HINT:
-
DTC communication uses the CAN communication system.
-
This DTC is output when the CAN communication system is malfunctioning and is not stored as a past DTC.
(f) ECM
-
The ECM is connected to the CAN communication system but CAN communication DTCs are not output.
-
If "Engine" is not displayed on the "CAN Bus Check" screen on the Techstream, proceed to "ECM Communication Stop Mode." See:
Component Tests and General Diagnostics/ECM Communication Stop Mode
(g) CENTER AIRBAG SENSOR ASSEMBLY
HINT:
-
The center airbag sensor assembly is connected to the CAN communication system but CAN communication DTCs are not output.
-
If "SRS Airbag" is not displayed on the "CAN Bus Check" screen on the Techstream, proceed to "Center Airbag Sensor Communication
Stop Mode." See: Component Tests and General Diagnostics/Center Airbag Sensor Communication Stop Mode
(h) MAIN BODY ECU
HINT:
-
The main body ECU is connected to the CAN communication system but CAN communication DTCs are not output.
-
If "Main Body" is not displayed on the "CAN Bus Check" screen on the Techstream, proceed to "Main Body ECU Communication Stop
Mode." See: Component Tests and General Diagnostics/Main Body ECU Communication Stop Mode
4. DTC COMBINATION TABLE
HINT:
-
o: Outputs under conditions shown above.
-
X: Not output, but may be output when one side of the CAN bus line opens.