xD L4-1.8L (2ZR-FE) (2008)
(c) Measure the resistance according to the values in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO DLC3 (CAN-H, CAN-L)
OK -- Continue to next step.
2. CONNECT CONNECTOR
(a) Reconnect the D-CAN junction connector.
NEXT -- Continue to next step.
3. CHECK CAN BUS LINE FOR SHORT TO +B (P-CAN J/C SIDE)
(a) Turn the ignition switch off.
(b) Disconnect the F47 P-CAN junction connector.
(c) Measure the resistance according to the values in the table below.
Standard resistance: