xD L4-1.8L (2ZR-FE) (2008)
NG -- CONNECT CONNECTOR
OK -- Continue to next step.
4. CHECK CAN BUS LINE FOR SHORT TO +B (P-CAN J/C - POWER STEERING ECU)
(a) Measure the resistance according to the values in the table below.
HINT: The resistance must be measured after the F47 P-CAN junction connector is disconnected.
Standard resistance:
NG -- CHECK CAN BUS LINE FOR SHORT TO +B (POWER STEERING ECU MAIN WIRE)
OK -- Continue to next step.
5. CHECK CAN BUS LINE FOR SHORT TO +B (P-CAN J/C - YAW RATE SENSOR)
NOTE: For vehicles without VSC, go to step 6.