xD L4-1.8L (2ZR-FE) (2008)
/Page-878022.png)
(a) Measure the resistance according to the values in the table below.
HINT: The resistance must be measured after the F47 P-CAN junction connector is disconnected.
Standard resistance:
NG -- CHECK CAN BUS LINE FOR SHORT TO +B (YAW RATE SENSOR BRANCH WIRE)
OK -- Continue to next step.
6. CHECK CAN BUS LINE FOR SHORT TO +B (P-CAN J/C - COMBINATION METER ECU)
(a) Measure the resistance according to the values in the table below.
HINT: The resistance must be measured after the F47 P-CAN junction connector is disconnected.
