xD L4-1.8L (2ZR-FE) (2008)
(b) Measure the resistance according to the values in the table below.
HINT: The resistance must be measured after the F46 D-CAN junction connector is disconnected.
Standard resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO BRAKE ACTUATOR (SKID CONTROL ECU)
(CAN-H, CAN-L)
OK -- REPLACE BRAKE ACTUATOR (SKID CONTROL ECU)
20. CHECK CAN BUS LINE FOR SHORT TO +B (ABS AND TRACTION ACTUATOR (SKID CONTROL ECU) BRANCH WIRE)
(a) Disconnect the A15 ABS and traction actuator (skid control ECU) connector.