xD L4-1.8L (2ZR-FE) (2008)
(a) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F46 D-CAN junction connector is disconnected.
Standard resistance:
NG -- CHECK CAN BUS LINES FOR SHORT CIRCUIT (ECM MAIN WIRE)
OK -- Continue to next step.
10. CHECK CAN BUS LINES FOR SHORT CIRCUIT (D-CAN J/C - BRAKE ACTUATOR (SKID CONTROL ECU))
NOTE: For vehicles without ABS, go to step 11.
(a) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F46 D-CAN junction connector is disconnected.
Standard resistance:
NG -- CHECK CAN BUS LINES FOR SHORT CIRCUIT (BRAKE ACTUATOR (SKID CONTROL ECU) BRANCH WIRE)
OK -- Continue to next step.
11. CHECK CAN BUS LINES FOR SHORT CIRCUIT (D-CAN J/C - ABS AND TRACTION ACTUATOR (SKID CONTROL ECU))
NOTE: For vehicles without VSC, go to step 13.