xD L4-1.8L (2ZR-FE) (2008)
(a) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F47 P-CAN junction connector is disconnected.
Standard resistance:
NG -- CHECK CAN BUS LINES FOR SHORT CIRCUIT (COMBINATION METER ECU BRANCH WIRE)
OK -- REPLACE P-CAN J/C
7. CHECK CAN BUS LINES FOR SHORT CIRCUIT (D-CAN J/C - P-CAN J/C)
(a) Turn the ignition switch off.
(b) Disconnect the F46 D-CAN junction connector.
(c) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F47 P-CAN junction connector is disconnected.
Standard resistance:
NG -- REPAIR OR REPLACE CAN MAIN WIRE OR CONNECTOR (D-CAN J/C - P-CAN J/C (CAN-H, CAN-L))
OK -- Continue to next step.
8. CONNECT CONNECTOR
(a) Reconnect the P-CAN junction connector.
NEXT -- Continue to next step.
9. CHECK CAN BUS LINES FOR SHORT CIRCUIT (D-CAN J/C - ECM)