xD L4-1.8L (2ZR-FE) (2008)
/Page-878066.png)
(a) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F46 D-CAN junction connector is disconnected.
Standard resistance:
NG -- CHECK CAN BUS LINES FOR SHORT CIRCUIT (MAIN BODY ECU BRANCH WIRE)
OK -- REPLACE D-CAN J/C
16. CHECK CAN BUS LINES FOR SHORT CIRCUIT (POWER STEERING ECU MAIN WIRE)
(a) Disconnect the F30 power steering ECU connector.
(b) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F47 P-CAN junction connector is disconnected.
Standard resistance:
