xD L4-1.8L (2ZR-FE) (2008)
/Page-878072.png)
(b) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F46 D-CAN junction connector is disconnected.
Standard resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO AIR CONDITIONING AMPLIFIER (CAN-H, CAN-L)
OK -- REPLACE AIR CONDITIONING AMPLIFIER
24. CHECK CAN BUS LINES FOR SHORT CIRCUIT (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE)
(a) Disconnect the F18 center airbag sensor assembly connector.
(b) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F46 D-CAN junction connector is disconnected.
Standard resistance:
