xD L4-1.8L (2ZR-FE) (2008)
/Page-1853005.png)
(b) Wind the seat belt with the retractor.
(c) When the seat belt is sufficiently wound, cut the seat belt approximately 10 cm (0.328 ft) from the retractor, as shown in the illustration.
HINT: The retractor resistance increases in correlation with how much the seat belt is wound.
(d) Check whether SST is functioning.
SST: 09082-00700
CAUTION: Always use the specified SST when activating the seat belt pretensioner.
(1) Connect the SST red clip to the positive battery terminal and the black clip to the negative battery terminal.
HINT: Do not connect the yellow connector. The yellow connector is for connections to the seat belt pretensioner.
(2) Press the SST activation switch and check that the LED of the SST activation switch turns on.
CAUTION: If the LED illuminates when the activation switch is not being pressed, SST may be malfunctioning. Do not use SST.
(e) Connect SST.
