xD L4-1.8L (2ZR-FE) (2008)
(3) After detaching the connector, confirm that the CPA protrudes beyond the rear of the housing.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: INSTALLATION
INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag
system before servicing See: Air Bag Systems/Service Precautions.
HINT: The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.
1. INSTALL FRONT AIRBAG SENSOR
NOTICE:
-
Do not use a front airbag sensor that has been dropped.
-
Do not subject the front airbag sensor to any impact or force.
(a) Confirm that the ignition switch is turned to OFF.
(b) Confirm that the negative battery terminal is detached.
CAUTION:
-
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag
sensor will cause the airbag to deploy.
-
Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.
(c) Connect the airbag connector.
(1) Check that the CPA is in the provisionally locked state.
(2) Push the CPA until it makes a click sound.
NOTE:
-
Engage the connector by pushing it straight.
-
Hold the CPA when engaging the connector.
-
Do not engage the CPA while pressing the CPA upper portion, otherwise, the half connection prevention mechanism will not function.
(3) Confirm that the rear side of the housing and the CPA rear surface are tightly fitted together.