xD L4-1.8L (2ZR-FE) (2008)
(a) Install the terminal insulator onto the generator coil.
NOTE: Pay attention to installation direction of the terminal insulator.
6. INSTALL GENERATOR REAR END COVER
(a) Install the generator rear end cover onto the generator coil with the 3 nuts.
Torque: 4.6 Nm (47 kgf-cm, 41 in-lbf)
7. INSTALL GENERATOR CLUTCH PULLEY
(a) Temporarily install the clutch pulley onto the rotor shaft.
(b) Set SST (A) and (B).
SST: 09820-63020
09821-63020
(c) Clamp SST (A) in a vise.
(d) Place the rotor shaft end into SST (A).