xD L4-1.8L (2ZR-FE) (2008)
(e) Fit SST (B) to the clutch pulley.
(f) Tighten the pulley by turning SST (B) in the direction shown in the illustration.
without SST - Torque: 111 Nm (1127 kgf-cm, 82 ft-lbf)
with SST - Torque: 84 Nm (857 kgf-cm, 62 ft-lbf)
NOTICE:
-
Use a torque wrench with a fulcrum length of 318 mm (12.52 in.).
-
This torque value is effective when SST is parallel to the torque wrench.
(g) Remove the generator assembly from SST.
(h) Check that the clutch pulley rotates smoothly.
(i) Install a new clutch pulley cap onto the clutch pulley.