xD L4-1.8L (2ZR-FE) (2008)
(a) Check the harness and connector (for automatic transaxle models).
(1) Disconnect the ignition switch connector.
(2) Disconnect the Park/Neutral Position (PNP) switch connector
(3) Disconnect the ECM connector.
(4) Measure the resistance according to the value(s) in the table below.
Standard resistance (Check for open):
Standard resistance (Check for short):
HINT: The wire between the park/neutral position switch and the ignition switch has a diode (refer to the wiring diagram). The current
flowing to the park/ neutral position switch is rectified by the diode.
(5) Reconnect the ignition switch connector.
(6) Reconnect the clutch start switch connector.
(7) Reconnect the ECM connector.