xD L4-1.8L (2ZR-FE) (2008)
(b) Remove the bolt and separate the speed sensor and flexible hose.
(c) Remove the 2 nuts from the lower side of the shock absorber.
HINT: Keep the bolt from rotating while loosening and removing the nuts.
(d) Clean the installation surfaces of the shock absorber and steering knuckle.
(e) Provisionally install the 2 nuts (Step A).
(f) Fully push or pull the axle hub in the direction of the required adjustment (Step B).
(g) Tighten the 2 nuts.
Torque: 164 Nm (1672 kgf-cm, 121 ft-lbf)
HINT: Keep the bolt from rotating while loosening and removing the nuts.
(h) Install the flexible hose and speed sensor with the bolt.
Torque: 29 Nm (300 kgf-cm, 22 ft-lbf)
NOTE: Install the flexible hose and speed sensor without twisting them.