xD L4-1.8L (2ZR-FE) (2008)
(b) Install the lower arm onto the steering knuckle with a new castle nut.
Torque: 98 Nm (999 kgf-cm, 72 ft-lbf)
NOTE: If the holes for the clip are not aligned, tighten the nut by a further turn of up to 60°.
(c) Install a new clip.
14. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
15. POSITION WHEELS FACING STRAIGHT AHEAD
16. STABILIZE SUSPENSION
(a) Lower the vehicle from the jack.
(b) Bounce the vehicle up and down several times to stabilize the suspension.
17. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH
(a) Fully tighten the 2 bolts.
Bolt A - Torque: 137 Nm (1397 kgf-cm, 101 ft-lbf)
Bolt B - Torque: 160 Nm (1631 kgf-cm, 118 ft-lbf)
18. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
19. INSTALL OUTER COWL TOP PANEL
20. INSTALL FRONT AIR SHUTTER SEAL RH
21. INSTALL FRONT WIPER MOTOR AND LINK See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation
22. INSTALL COWL TOP VENTILATOR LOUVER LH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation
23. INSTALL COWL TOP VENTILATOR LOUVER RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation
24. INSTALL HOOD TO COWL TOP SEAL See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper Motor/Installation
25. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation
26. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation