xD L4-1.8L (2ZR-FE) (2008)
6. TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT: Use the same procedure for the LH side.
7. INSTALL FRONT STABILIZER BAR
8. INSTALL FRONT STABILIZER BRACKET NO.1 LH
9. INSTALL FRONT STABILIZER BRACKET NO.1 RH
HINT: Use the same procedure for the LH side.
10. INSTALL POWER STEERING GEAR
(a) Install the power steering gear onto the front suspension crossmember with the 2 bolts and 2 nuts.
Torque: 96 Nm (979 kgf-cm, 71 ft-lbf)
NOTE: Keep the nut from rotating while turning the bolt.
11. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
(a) Support the front suspension crossmember with a transmission jack.
(b) Provisionally install the front suspension crossmember onto the body with the 6 bolts.
(c) By inserting SST into the datum holes in the front suspension crossmembers RH and LH alternately, tighten bolts A, B and C on both sides to
the specified torque, in several steps.
SST: 09670-00011
Torque: 70 Nm (714 kgf-cm, 52 ft-lbf)for bolt A
Torque: 160 Nm (1631 kgf-cm, 118 ft-lbf)for bolt B
Torque: 95 Nm (969 kgf-cm, 70 ft-lbf)for bolt C
NOTICE:
-
Insert SST into the datum hole in a vertical orientation.
-
If SST can not be inserted into the datum hole vertically, loosen all the bolts and then insert SST again.