xD L4-1.8L (2ZR-FE) (2008)
without union nut wrench - Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
with union nut wrench - Torque: 14 Nm (144 kgf-cm, 10 ft-lbf)
NOTICE:
-
This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a
fulcrum length of 22 mm (0.866 in.) .
-
This torque value is effective when union nut wrench is parallel to a torque wrench.
10. INSTALL REAR RH FLEXIBLE HOSE
HINT: The installation procedure for the RH side is the same as that for the LH side.
11. INSTALL SKID CONTROL SENSOR WIRE
(a) Install the skid control sensor wire onto the axle beam with the nut.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
(b) Connect the skid control sensor wire connector.
12. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
13. STABILIZE SUSPENSION
(a) Lower the vehicle from the jack.
(b) Bounce the vehicle up and down several times to stabilize the suspension.
14. FULLY TIGHTEN REAR AXLE BEAM See: Axle Beam/Service and Repair/Installation
15. FULLY TIGHTEN REAR SHOCK ABSORBER LH See: Suspension Strut / Shock Absorber/Service and Repair/Rear Shock
Absorber/Installation
16. FULLY TIGHTEN REAR SHOCK ABSORBER RH
HINT: The installation procedure for the RH side is the same as that for the LH side.
17. FILL RESERVOIR WITH BRAKE FLUID See: Brakes and Traction Control/Brake Bleeding/Service and Repair/Replacement
18. BLEED MASTER CYLINDER See: Brakes and Traction Control/Brake Bleeding/Service and Repair/Replacement
19. BLEED BRAKE LINE See: Brakes and Traction Control/Brake Bleeding/Service and Repair/Replacement
20. BLEED BRAKE ACTUATOR (w/ VSC) See: Brakes and Traction Control/Brake Bleeding/Service and Repair/Replacement
21. CHECK FLUID LEVEL IN RESERVOIR See: Brakes and Traction Control/Brake Bleeding/Service and Repair/Replacement