xD L4-1.8L (2ZR-FE) (2008)
Seals and Gaskets: Service and Repair
Replacement
U341E AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: REPLACEMENT
REPLACEMENT
1. REMOVE ENGINE UNDER COVER
2. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug and gasket, and drain the ATF.
(b) Install a new gasket and the drain plug.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
3. REMOVE FRONT WHEEL
4. REMOVE FRONT AXLE HUB NUT See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
5. SEPARATE FRONT SPEED SENSOR See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
6. SEPARATE FRONT STABILIZER LINK ASSEMBLY See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
7. SEPARATE TIE ROD END SUB-ASSEMBLY See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
8. SEPARATE FRONT LOWER SUSPENSION ARM See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
9. SEPARATE FRONT AXLE ASSEMBLY See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
10. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
11. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
12. REMOVE FRONT TRANSAXLE CASE OIL SEAL
(a) Using SST, remove the front transaxle case oil seal.
SST: 09308-00010
13. REMOVE TRANSAXLE CASE OIL SEAL
(a) Using SST, remove the transaxle case oil seal.
SST: 09308-00010