xD L4-1.8L (2ZR-FE) (2008)
(f) Turn the nut on the transmission control cable assembly and push in the lock.
(g) Install the transmission control cable assembly onto the shift lever retainer.
NOTE:
-
Install the cable with the protruding portion of the cable outer facing upward.
-
After installing, check that the lock of the cable outer is protruding beyond portion A-A, as shown in the illustration.
(h) Connect the transmission control cable assembly to the transmission floor shift assembly.
NOTE: Connect the control cable so that the adjusting mechanism lock of the control cable is installed on the left side of the vehicle.
2. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
(a) Install the front No. 1 floor heat insulator with the 2 bolts and the nut.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
3. INSTALL FRONT EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation