xD L4-1.8L (2ZR-FE) (2008)
Seals and Gaskets: Service and Repair
Installation
C50 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION
INSTALLATION
1. INSTALL TRANSMISSION CASE OIL SEAL
(a) Coat the lip of a new oil seal with MP grease.
(b) Using SST and a hammer, install the new oil seal.
SST: 09309-37010
Drive in depth:
9.6 to 10.2 mm (0.378 to 0.402 in.)
NOTE: Do not damage the oil seal lip.
2. INSTALL TRANSAXLE CASE OIL SEAL
(a) Coat the lip of a new oil seal with MP grease.
(b) Using SST and a hammer, install the new oil seal.
SST: 09710-26011
09710-05061
Drive in depth:
1.6 to 2.2 mm (0.063 to 0.087 in.)
NOTE: Do not damage the oil seal lip.
3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Installation
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Installation
5. INSTALL FRONT AXLE ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Installation
6. INSTALL FRONT AXLE ASSEMBLY RH
HINT: The installation procedure for the RH side is the same as that for the LH side.
7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Installation
8. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: The installation procedure for the RH side is the same as that for the LH side.
9. INSTALL TIE ROD END SUB-ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Installation