xD L4-1.8L (2ZR-FE) (2008)
(f) Connect the control select cable to the shift lever with the clip.
NOTICE:
-
Connect the control select cable so that the adjusting mechanism lock of the control select cable is installed on the left side of the vehicle.
-
Insert the clip in the direction shown in the illustration.
(g) Adjust the length of the control select cable.
(1) Slide the adjuster case cover in the direction shown in the illustration (Illustration A).
(2) Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
(3) Press the lock piece into the adjuster case and lock it (Illustration B).
(4) Slide the cover in the direction shown in the illustration (Illustration C).
NOTE: Slide the cover past the protrusion portion of the lock piece (Illustration D).
2. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
(a) Install the front No. 1 floor heat insulator with the 2 bolts and nut.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
3. INSTALL FRONT EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
4. CONNECT HEATED OXYGEN SENSOR CONNECTOR
5. INSTALL FRONT FLOOR CENTER BRACE See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Installation
6. INSTALL FRONT CONSOLE BOX
7. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
8. INSTALL CONSOLE BOX CARPET
9. INSTALL CONSOLE BOX REAR COVER
10. INSTALL UPPER CONSOLE PANEL
11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY