seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Clutch pedal: Removing and installing|Installation > < Clutch pedal: Removing and installing

Leon Mk1

Removing
Removing
–  Remove the neutral overpass spring → Chapter
Vehicles with switch on the clutch pedal
   
–  Pull -1- pin connector off clutch pedal switch.
–  Pull the clutch pedal switch from its housing.
–  Remove the fixing bush for the clutch pedal switch It will be neces-sary to break it to remove it.
Continued for all vehicles
  N23-0142
Unblock the clutch pump actioning rod from the clutch pedal as follows:
–  Fit tool -T20059A- on the housing lugs -arrow-. Use the points -T20059A/1- of Ø 5.6 with the milling diagonally, so that the longest point is on the right side of the pedal.
–  Check the housing lugs with tool -T20059A-, and at the same time move the clutch pedal backwards.
  E30-0049
–  Remove the safety ring -A- from the left side of the pedal shaft. To do this free the central tab with a screwdriver, and move downwards to remove it -arrows-.
  E30-0030
–  Remove the safety ring -A- from the right side of the pedal shaft. To do this lift the central tab with a screwdriver, and move the catch down -arrows-.
–  Move the pedal shaft to the right until the clutch pedal can be removed.
–  Remove the clutch pedal, together with the bearing bushes.
  E30-0029

Clutch pedal: Removing and installing|Installation > < Clutch pedal: Removing and installing