Leon Mk1
Adjustment chart |
Note
If work is carried out on the gearbox, it will only be necessary to adjust the input shaft, the secondary shaft or the differential when parts have been replaced that influence the gearbox adjustment. To avoid unnecessary work check the following table. |
Adjustment must be made to the | ||||
Input shaft → Chapter | Secondary shaft → Chapter | Differential → Chapter | ||
Part replaced | Gearbox | x | x | |
clutch housing | x | x | x | |
Input shaft: | x | |||
Output shaft (differential ring stop pinion) | x | |||
Differential casing | x | |||
Tapered roller bearing for input shaft | x | |||
Tapered roller bearings for output shaft | x | |||
Tapered roller bearings for differential | x | |||
4th gear wheel | x |