Leon Mk1
Gear selection mechanism:installation overview |
1 - | Selector shaft |
2 - | Limit ring |
3 - | Ball sleeves |
q | Remove → Fig. |
q | Insertion → Fig. |
4 - | Selector rod cover |
5 - | Reverse gear light switch |
q | 20 Nm |
q | Apply a fine coat of grease to the lug → Parts catalogue |
6 - | Plug |
q | For gearbox breather |
7 - | Return lever |
q | Installation position → Fig. |
q | Two versions: metal and plastic |
q | The plastic transfer lever is not equipped with bearing bushings -8- or retaining rings -10- |
8 - | Bearing bush |
q | is not installed on plastic transfer lever |
9 - | Sealing ring |
q | Remove by levering with a screwdriver |
q | Insertion → Fig. |
10 - | Securing washer |
q | is not installed on plastic transfer lever |
11 - | Hexagonal nut |
q | 25 Nm |
q | Self-locking |
q | Always replace. |
12 - | Selection rod |
q | Position so that the interrupted division of the teeth is inserted on the selector shaft |
q | Can be replaced with gearbox in vehicle |
q | Installation position → Fig. |
13 - | Cover |