seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Gear selection mechanism (gearbox side) removing and fitting > < Clutch system: bleeding of air
Check and refill
Check and refill
–  Raise vehicle.
   
–  Vehicles with diesel engine: Unscrew bolts - 1 … 3- and remove center noise insulation.
  A10-1565
–  Vehicles with diesel engine: Unscrew bolts -1- … -2- and remove center noise insulation.
  A10-10761
–  Loosen oil level test bolt -arrow-.
  Note
Oil level is correct when the oil reaches the bottom edge of filling hole.
Oil specification for gears → Chapter.
–  If the oil level is not correct, complete oil level.
–  Unscrew control lid, start engine and let the gears work with engaged gear for about 2 minutes.
–  Stop the engine, remove oil cap and check level again, top up if necessary.
–  Tighten the gearbox oil level control cap to a torque of 25 Nm.
–  Install the middle soundproofing.
  V39-1959

Gear selection mechanism (gearbox side) removing and fitting > < Clutch system: bleeding of air