Leon Mk1
Gear selection mechanism: assembly overview |
1 - | Selector shaft |
2 - | Stop ring |
3 - | Ball sleeve |
q | Remove → Fig. |
q | Insertion → Fig. |
4 - | Selector rod cover |
5 - | Bolt. |
q | 15 Nm |
6 - | Reversing light switch |
q | 20 Nm |
q | Apply a fine coat of grease to the lug → Spare parts catalogue |
7 - | Idler rod |
q | Installation position → Fig. |
8 - | Sealing ring |
q | Remove by levering with a screwdriver |
q | Insertion → Fig. |
9 - | Panel |
q | For gearbox breather |
10 - | Conical hexagon bolt |
q | 25 Nm |
q | Self-locking |
q | Always replace |
11 - | Gearbox selector lever |
q | Position so that the interrupted division of the teeth is inserted on the selector shaft |
q | Can be replaced with gearbox in vehicle |
q | Installation position → Fig. |
12 - | Sealing cap |
13 - | Elastic clip |
q | Fit on cover, where applicable. |