Leon Mk1
Reverse gear shaft: assembly overview |
1 - | clutch housing |
2 - | Axial/radial needle bearing |
q | Removing → Fig. |
q | After installation, the axial/radial needle bearing must always be replaced. |
q | Installing → Fig. |
3 - | Reverse gear |
4 - | Circlip |
q | Use pliers -A 81124- to remove the safety ring. |
q | Always replace |
5 - | Reverse gear mobile pinion |
q | Fitting position: the pinion collar must face pinion of reverse gear |
6 - | Reverse shaft |
q | Removing → Chapter |
7 - | Axial/radial needle bearing |
q | Removing → Fig. |
q | After removal, the axial/radial needle bearing must always be replaced. |
q | Installing → Fig. |
8 - | Reverse shaft support |