seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Final drive, differential, differential lock > < Reverse gear shaft: Assembly overview

Leon Mk1

Reverse gear shaft: Disassembling and assembling
Reverse gear shaft: Disassembling and assembling
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
   
Special tools and workshop equipment required
t  Extractor kit -T20140 -, see equivalent → Anchor
t  Extractor kit -U 40100B -, see equivalent → Anchor
t  Kit (case) -U 40200A-
t  Kit (case) -U 40300-

   
Remove the support axial/radial needle bearing of the clutch housing
–  Locate adapter -T20140/14- on axial/radial bearing.
–  Place adapter -T20140/1- on clutch casing and screw extractor shaft into adapter -T20140/14 - until claws expand.
–  Work nut -1- until outer track of small roller bearing is extracted.
  Note
Release the claws and then expand again after the outer ring has been pulled out by approx.1 mm so that it sits completely on the base of the bearing.
  E35-0187
Install the support axial/radial needle bearing of the clutch housing
  E35-0044
Remove the support axial/radial needle bearing from the reverse gear shaft
  E35-0045
Fit the support axial/radial needle bearing for the reverse gear shaft
  E35-0046

Final drive, differential, differential lock > < Reverse gear shaft: Assembly overview