Leon Mk1
Oil sump, oil strainer, selection unit and internal cable harnesses: Assembly overview |
1 - | ATF level testing bolt (M10) - 27 Nm |
q | Replace the seal → Item |
q | ATF level: verification and topping up → Chapter |
q | Also for draining ATF, depending upon version |
2 - | Seal |
q | replace |
3 - | Overflow tube - 1 Nm |
q | Screw into the oil sump |
4 - | Oil pan |
q | removing and fitting → Chapter |
5 - | Bolt M6 - 7 Nm |
q | 8 x, for securing the oil sump with the oil sump gasket on the gearbox housing |
6 - | Seal |
7 - | Magnet |
q | 2 units in the grooves of the oil sump |
q | Clean before fitting |
8 - | Bolt M6 - 11 Nm |
q | 3 x to secure ATF strainer on the selection unit |
9 - | ATF strainer |
q | removing and fitting → Chapter |
10 - | Bolt M6 |
q | 12 x of different lengths for attachment of the selection unit to the gearbox |
q | replace |
q | Note the correspondence → Chapter „Removing and installing the selector housing“ |
11 - | Selection unit |
q | removing and fitting → Chapter |
q | Identification of the solenoid valves → Chapter |
12 - | Bolt M6 - 5.5 Nm |
13 - | Gearbox input speed sender -G182- |
q | with cable and 2 pin connector |
q | removing and fitting → Chapter |
14 - | Bolt M6 - 5.5 Nm |
15 - | Gearbox output speed sender -G195- |
q | with cable and 2 pin connector |
q | removing and fitting → Chapter |
16 - | Gearbox |
17 - | ATF breather |
18 - | Gear oil cooler |
q | removing and fitting → Chapter |
19 - | Multifunction switch -F125- |
q | Checked by self-diagnosis |
q | removing and fitting → Chapter |
q | Adjust convergence → Chapter |
20 - | Seal |
q | replace |
21 - | ATF drain bolt (M18) - 39 Nm. |
q | This is no longer used as a drain screw, depending upon version |
22 - | Lever |
q | For the selector lever, interior, beside the selection unit |
q | removing and fitting → Chapter „Removing and installing the selector housing“ |
23 - | Plate |
24 - | Nut, -10 Nm |
q | Note installation position → Chapter „Removing and installing the selector housing“ |
25 - | Large spring |
26 - | Small spring |
27 - | Damper cylinder |
28 - | 8 terminal cable harness with Gearbox oil temperature sender -G93- integrated |
q | with O-ring on the connector |
q | Renew O-ring. |
q | Connected components → Chapter |
q | removing and fitting → Chapter |
29 - | Bolt M6 - 5.5 Nm |
30 - | Cable harness with 14 terminal connector |
q | with O-ring on the connector |
q | Renew O-ring. |
q | Connected components → Chapter |
q | removing and fitting → Chapter |
31 - | Bolt M6 - 5.5 Nm |