Leon Mk1
Note
|
| 1 - | Gearbox |
| 2 - | Shim |
| q | For differential |
| q | Determine thickness → Chapter |
| 3 - | Outer ring of roller bearing |
| q | Remove → Fig. |
| q | Insertion → Fig. |
| 4 - | Inner ring of roller bearing |
| q | Remove → Fig. |
| q | Insertion → Fig. |
| 5 - | Differential casing |
| q | with starter ring gear riveted-on |
| 6 - | Inner ring of roller bearing |
| q | Remove → Fig. |
| q | Insertion → Fig. |
| 7 - | Outer ring of roller bearing |
| q | Remove → Fig. |
| q | Insertion → Fig. |
| 8 - | Washer |
| q | 0.65 mm thick |
| q | Installation position: the interior diameter rebate should point towards the seal → Item |
| 9 - | clutch housing |
| 10 - | Insert shaft oil seal |
| q | replace with gearbox installed → Chapter |
| 11 - | O ring |
| q | Renew |
| 12 - | Insert shaft dust guard |
| 13 - | 25 Nm conical bolt |
| q | Screw in with threaded element → Item |
| 14 - | Insert shaft |
| 15 - | Compression spring for the flanged or insert shaft |
| q | Fitted behind the flanged or insert shaft |
| 16 - | Attack washer |
| q | Installation position: Collar must face spring, webs must face tapered ring |
| 17 - | Conical ring |
| q | With rebate for the thrust washer |
| q | Installation position: with conical side towards the differential drive |
| 18 - | Securing ring |
| q | The conical ring, the thrust washer and the compression spring all remain in place when the flanged or insert shaft is removed |
| 19 - | large planetary gear |
| q | Installing → Fig. |
| 20 - | Planet gear shaft |
| q | Release using a mandrill |
| q | Installing → Fig. |
| 21 - | Spring pin |
| q | To hold the satellite shaft |
| q | Removing and fitting → Fig. |
| 22 - | small planetary gears |
| q | Installing → Fig. |
| 23 - | Threaded component |
| 24 - | Set of thrust washers |
| q | Lubricate with gear oil before installing |
| 25 - | Articulation flange |
| 26 - | Flanged shaft oil seal |
| q | replace with gearbox installed → Chapter |
