SEAT Workshop Service and Repair Manuals

Clutch housing: Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Push rod -T20130-, see equivalent → Anchor

t	Extractor kit -T20140-, see equivalent → Anchor

t	extractor kit -T20143-, see equivalent → Anchor

t	Kit (case) -U 40200A-, see equivalent → Anchor

t	Push rod -U 40204-, see equivalent → Anchor

t	Kit (case) -U 40450A-, see equivalent → Anchor

–  Remove input shaft seal by levering with extractor -T20143/1-.

–  Fit seal flush with installation tool -T20130-

Extract the bearing socket for the control rod –  Extract the bearing sockets using the adapter -T20140/14- and the pressure tool -T20129- .

Extract the bearing socket for the control rod –  Use the correct diameter according to the diameter of the socket and insert to the limit.

Extract the point crown from the clutch housing –  Extract the bearing sockets using the adapter -T20140/1- and the extractor kit -T20140-.   Note The point crown is damaged by removal and must always be replaced. –  Extraction of the needle bearing.

Insert the point crown into the clutch housing –  When inserting the thrust washer for the inverter shaft -B- must be fitted onto the points crown -A-.

Insert the reverse gear prong shaft into the clutch housing