Leon Mk1
Gearbox housing and gear selection shaft: Assembly overview |
1 - | 25 Nm conical bolt |
2 - | Articulation flange |
q | Removing and fitting → Chapter |
3 - | Securing ring |
q | For the cover of the drive shaft |
4 - | Sealing cover of the input shaft |
q | Removing and fitting → Chapter |
q | Always replace |
5 - | Securing ring |
6 - | Reverse light switch, -20 Nm |
7 - | Seal |
q | Renew |
8 - | Oil empty plug |
q | Allen screw, -30 Nm |
q | Multi-point socket head bolt, 45 Nm |
9 - | Seal |
q | Renew |
10 - | Locking bolt for selector shaft, 30 Nm |
11 - | Bolt - 15 Nm + 90° (1/4 turn further) |
q | With secured washer |
q | Renew |
12 - | Bolt - 15 Nm + 90° (1/4 turn further) |
q | Without washer |
q | Renew |
13 - | Gear selection mechanism |
q | Disassembling and assembling the heating system → Chapter |
q | Remove with the gearbox fitted: |
– | Remove air cleaner housing → Rep. Gr.23. |
– | Remove the control cables and the selection rod. |
– | Unscrew the locking bolt and pull out the gearbox operation mechanism |
14 - | Bolt, 20 Nm |
q | Renew |
15 - | O ring |
q | Renew |
16 - | clutch housing |
q | Repairing → Chapter |
17 - | Gearbox |
q | Repairing → Chapter |