SEAT Workshop Service and Repair Manuals

Cover of the drive shaft: Removing and installing Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Puller -T10143-, see equivalent → Anchor

t  Extractor kit -T20140-, see equivalent → Anchor t  Removing → Anchor t  Installing → Anchor Removing –  Raise the vehicle –  Remove front left-hand wheel.

–  Remove bolts -1 ... 3- and remove central noise insulation. –  Remove left noise insulation → Rep. Gr.66

–  Remove the circlip -A- for the sealing cover of the input shaft.

–  Punch a hole through the middle of the rubber of the cover of the input shaft using a screwdriver. –  Remove the rubber seal cover from the input drive using the extractor kit -T20140-. Installing Installation is carried out in the reverse sequence; note the following:   Note Always replace the sealing cover and, when applicable, the circlip fitted.

–  Insert the sealing cover using the pressure tool -T10143- as far as possible in the gearbox housing.

–  Secure the sealing cover with the new circlip -A-. –  Check hydraulic oil level and top-up if necessary → Chapter.