Leon Mk1
Input shaft, secondary shaft, differential gear and gearbox change prongs. Assembly overview |
1 - | Secondary shaft for 1st to 4th gear |
q | Disassembling and assembling the heating system → Chapter |
q | Installation position → Fig. |
2 - | Control rod with prongs for 1st and 2nd gear |
q | Installation position → Fig. |
3 - | Selector rod with selector fork for 3rd and 4th gear |
q | Installation position → Fig. |
4 - | Secondary shaft for 5th/6th and reverse gear |
q | Disassembling and assembling the heating system → Chapter |
q | Installation position → Fig. |
5 - | Selector rod with selector fork for 5th and 6th gear |
q | Installation position → Fig. |
6 - | Reverse gear prong |
q | Installation position → Fig. |
7 - | Input shaft: |
q | Disassembling and assembling the heating system → Chapter |
8 - | Reverse gear shaft: |
q | With thrust washer |
9 - | Attack washer |
10 - | Vent valve |
q | connect with the clutch slave cylinder → Item |
11 - | clutch housing |
12 - | Input shaft oil seal: |
13 - | O ring |
q | Renew |
q | Fit in the tube connection |
q | Apply brake fluid before fitting |
14 - | Clutch slave cylinder with clutch release collar |
15 - | Bolt, 12 Nm |
q | 3 Units |
q | Renew |
16 - | 25 Nm conical bolt |
17 - | Articulation flange |
q | Removing and fitting → Chapter |
18 - | Differential: |
q | Disassembling and assembling |