Leon Mk1
Selector forks - exploded view |
Note
It is not necessary to dismantle the gearbox prong unit → Item to remove and assemble the gearbox selector rods, the fastening washers and the ball bearings. |
1 - | Selector fork cluster with selector plates |
2 - | Selector segment for 3rd and 4th gear |
q | Identification → Fig. |
q | The gear selection group should still be free to rotate slightly after fitting the pressure ring |
3 - | Angular contact ball bearing |
q | 4x |
q | Removing → Fig. |
q | Driving in → Fig. |
4 - | Clamping washer |
q | replace |
q | Removing → Fig. |
q | Fitting → Fig. |
5 - | 1st/2nd gear selector segment |
q | Identification → Fig. |
q | The gear selection group should still be free to rotate slightly after fitting the pressure ring |
q | Prong with gear selection → Fig. |
6 - | 5th gear selector fork with selector segment |
q | Identification → Fig. |
q | The gear selection can not be separated from the prong |
7 - | Bearing pin |
q | For the selector fork of 5th gear |