seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Dismantling and assembling gearbox > < Dismantling and assembling selector forks

Leon Mk1

Locking pin for the selector mechanism: Removing and installing
Locking pin for the selector mechanism: Removing and installing
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Tappet -T10203 -, see equivalent → Anchor
  W00-1335
Remove the locking pin -A- from the gearbox operation mechanism shaft cover
–  Remove the external part of the retainer pin.
–  Extract the locking pin by levering using a screwdriver.
  N34-1801
Adapt the locking pin in the gearbox operation mechanism shaft cover
Fitting position:
The mark -1- must coincide with the mark -2- on the gearbox operation mechanism shaft cover.
–  Insert the locking pin in the gearbox operation mechanism shaft cover using the installation tool -T10203 -.
  N34-10199

Dismantling and assembling gearbox > < Dismantling and assembling selector forks