Leon Mk1
Removing and installing viscous coupling and pinion housing |
1) | Adjustment work is required if these components are renewed, adjustment overview → Chapter. |
1 - | Oil seal |
q | Levering out with screwdriver. |
q | Always renewing. |
2 - | Centring nut, 160 Nm |
q | Removing → Anchor. |
q | Installing → Anchor. |
q | Before screwing on to shaft bevel gear, moisten with locking fluid -D 000 600 A2-. |
3 - | Viscous coupling |
q | Checking function → Chapter. |
q | Store only in installation position. |
4 - | Pinion housing → Note |
q | Removing → Anchor. |
q | Pressing in → Anchor. |
q | Repairing shaft bevel gear bearing → Chapter. |
5 - | Hexagon bolt, 25 Nm |
6 - | O-ring |
q | Always renewing. |
7 - | Shim S3 |
q | Marking holes -arrows- point towards rear axle housing at top. |
q | Noting thickness. |
q | Adjustment overview → Chapter. |
8 - | Rear axle housing → Note |