Leon Mk1
|
|
|
t | Output gear must be removed for dismantling and assembling parking lock → Chapter „Removing and installing drive shaft“. |
1 - | Circlip |
q | Always renewing. |
2 - | Washer |
3 - | Shaft for detent lever |
q | Is secured by circlip and bearing cap of drive shaft. |
q | Depending on design, with groove for circlip. |
4 - | Return spring |
q | Installing → Fig.. |
5 - | Detent lever |
q | Inserting with return spring → Fig.. |
6 - | Parking lock gear |
q | Rounded side faces teeth of drive shaft. |
7 - | Bolt, 14 Nm |
8 - | Support plate |
q | Installing → Fig.. |
9 - | Guide plate |
q | Inserting before supporting plate → Fig.. |
10 - | Vehicle speed sender -G68- |
q | Is checked by self-diagnosis in vehicle → Automatic gearbox 099, four-wheel drive -Self-diagnosis-; Rep. Gr.01. |
11 - | Bolt, 10 Nm |
12 - | O-ring |
q | Always renewing. |
13 - | Bolt, 15 Nm |
q | With oil seal. |
q | Always renewing. |
14 - | Gearbox housing |
15 - | Bolt, 10 Nm |
16 - | Lever |
q | For selector shaft. |
17 - | Oil seal |
q | Levering out with screwdriver. |
q | Driving in flush with -VW 423-. |
18 - | Selector shaft with selector segment and detent segment |
q | Inserting together with engaging lever. |
q | Removing and installing → Fig.. |
19 - | Engaging lever |
q | Inserting together with selector shaft and detent segment. |
20 - | Spring pin |
q | Driving in after inserting engaging lever → Fig.. |
q | Driving out with a drift. |
21 - | Lock washer |
q | Removing and installing → Fig.. |
22 - | Bolt, 10 Nm |
23 - | Spool valve control |
q | Adjusting → Chapter „Removing and installing valve body“. |
q | Always renewing steel spring → Fig.. |
24 - | Bolt, 10 Nm |
25 - | Spring for selector segment |
26 - | Bolt, 10 Nm |
27 - | Bolt, 10 Nm |
28 - | Retainer |
q | For multi-function switch. |
29 - | Multi-function switch -F125- |
q | For removing. |
q | Removing noise insulation tray. |
q | Pulling out connector and placing oil pan under gearbox. |
q | When installing, checking connector is correctly sealed. |
q | Toping up ATF after installing → Chapter. |
q | Inserting so that 1 pin each is resting on a slope of the detent segment. |
q | Is checked by self-diagnosis in vehicle → Automatic gearbox 099, four-wheel drive -Self-diagnosis-; Rep. Gr.01. |
30 - | O-ring |
q | Always renewing. |
31 - | O-ring |
q | Always renewing. |
32 - | Gearbox speed sender -G38- |
q | Is checked by self-diagnosis in vehicle → Automatic gearbox 099, four-wheel drive -Self-diagnosis-; Rep. Gr.01. |
33 - | Bolt, 10 Nm |
|
|
|
|