seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Overview - ?K4? components ?from below? > < 5th gear clutch ?K4?

Leon Mk1

Overview - “K4” components “from above”
Overview - “K4” components “from above”
The clutch will now be dismantled for cleaning. No repairs can be made.
   
1 - Clutch housing “K4”
2 - Piston
3 - Spring
4 - Spring seat
5 - Retaining ring
q   Ring will not be renewed. Therefore, remove and install carefully, not over-stretching it with force.
6 - Outer plate
7 - Inner plate
8 - Last outer plate
q   Thicker than the other outer plates.
9 - Retaining ring
q   Ring will not be renewed. Therefore, remove and install carefully, not over-stretching it with force.

Dismantling “K4”“from above”
–  Remove retaining ring for plates.
–  Remove plates.
   
–  Slowly and carefully press down spring seat only far enough that the ring can be removed.
–  Remove retaining ring.
–  Remove spring and spring seat.
–  Drive piston out of clutch housing.
–  To do this, gently strike a plastic mallet against the upper edge of the clutch housing.
Assembling “K4” clutch housing “from above”
–  Carefully press piston by hand into clutch housing to stop.
–  Lay spring, spring seat and retaining ring in clutch housing.
  N38-10044
–  Slowly and carefully press down spring seat only far enough that the ring can be installed.
–  Install retaining ring.
  N38-10044

Overview - ?K4? components ?from below? > < 5th gear clutch ?K4?